Mantel Top (#7)
Washer
1 1/4"
Screw
Mantel
Side
Assembly
Figure 4 - Attaching Mantel Top
Gas Fireplace Installation
1.Fireplace should be fully assembled. See Assembling Fireplace in fireplace owner’s manual.
2.Place mantel base close to installation location. See fireplace owner’s manual for installation clearances. Leave enough room to insert fireplace from back of mantel.
3.Install gas line. See Connecting to Gas Supply in fireplace owner’s manual. Remember to leave access to the gas shutoff valve somewhere on the base or where it is accessible to the user.
4.Check for leaks. See Checking Gas Connections in fireplace owner’s manual.
5.Position fireplace inside mantel (see Figure 5). Carefully posi- tion gas lines. Important: Use caution when positioning fireplace on base. Base may scratch easily.
6.Fireplace with louver door: Lower bottom louver door. Use two screws provided in hardware package and attach fireplace to wooden base. Close louver door
Fireplace with fixed louver: Before installing logs or burner assembly (see owner’s manual) remove screws securing floor to assembly. Lift floor for access to bottom of fireplace. Use two screws provided in fireplace hardware package and attach fireplace base to wooden base. Reinstall floor with screws removed previously.
7.If mantel trim that came with your fireplace has not yet been assembled, see Assembling Trim. Place metal trim on shoulder screws. Firmly snap trim assembly over shoulder screws on fireplace.
8.Carefully push mantel and base into position against wall.
Figure 5 - Installing Fireplace
electric Fireplace Installation
This mantel can be used with Dimplex 26" Electric Fireplace. Electric fireplaces install from the front of mantel. To install electric fireplace see fireplace instruction manual.
Assembling Perimeter Trim (If Supplied with Gas Fireplace)
1.Remove packaging from three pieces of metal trim.
2.Locate two adjusting plates with set screws, and two shims in the hardware packet.
3.Align shim under adjusting plate as shown in Figure 6.
4.Slide one end of adjusting plate/shim in slot on mitered edge of top trim (see Figure 6).
5.Slide other end of adjusting plate/shim in slot on mitered edge of side trim (see Figure 6).
6.While firmly holding edges of trim together, tighten both set screws on the adjusting plate with slotted screwdriver.
7.Repeat steps 2 through 6 for other corner.
Set Screws | Slot |
| |
Adjusting | Top Trim |
| |
Plate | Mitered Edge |
Shim | Side Trim |
| Slot |
Figure 6 - Assembling Trim
www.desatech.com |