Desa W32RO installation instructions Assembly And Installation Instructions, Assembling Mantel

Models: W32RO

1 4
Download 4 pages 60.61 Kb
Page 1
Image 1
W32RO Mantel and Base

W32RO Mantel and Base

ASSEMBLY AND INSTALLATION INSTRUCTIONS

Important: Read entire instruction sheet before assembling or installing mantel kit.

This mantel is only approved for use with DESA Heating, LLC 32" fireplace systems. Do not use mantel with any other product.

This mantel kit contains the following:

Mantel pieces - unassembled and marked as follows:

#1 Base

Assembling Mantel

ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: Use only 1/2" screws to attach metal angle brackets. Damage to mantel will result if other screws are used for this purpose.

IMPORTANT: More than one person is required to lift assembled mantel. Lift mantel by leg assemblies. Lifting by header or mantel top could damage mantel.

#2 Right Side with arrow

 

#3 Right Front Leg with arrow

 

#4 Left Side with arrow

 

#5 Left Front Leg with arrow

 

#6 Header with arrow

 

#7 Top

 

• Hardware Kit*

 

14 - Metal Brackets

118937-01

28 - Screws M6 x 12 mm (1/2")

121149-01

11 - Screws M6 x 30 mm (1 1/4")

121335-01

11 - Washers M6

121336-01

1 - Allen Wrench

121337-01

* Extra hardware may be included.

 

If any wood pieces are missing or damaged, contact the dealer where you purchased this mantel for replacement. If hardware is missing or damaged, contact DESA Heating, LLC at 1-866-672-6040 for referral. You can also visit DESA Heating, LLC's web site at www.desatech.com.

Note: Gather all mantel pieces together before assembling.

When assembling mantel do not tighten screws completely until told to do so. There should be some play in the pieces to allow for proper alignment and best possible fit. It is very important that more than one person assemble mantel. Panels must be held in proper alignment to each other while tighten- ing screws to assure fewer gaps and proper surface align- ment. When tightening screws, do not over tighten. This may cause threads to strip. The supplied Allen wrench should be used rather than a power screwdriver. Panels have threaded inserts installed at screw locations. Screws should start and turn easily in threaded holes when assembled according to instructions. Do not force screws into holes.

IMPORTANT: A serial number label is located inside of right side panel and on outside package. When calling to request technical assistance or for replacement parts please have serial number ready.

www.desatech.com

Page 1
Image 1
Desa installation instructions Assembly And Installation Instructions, Assembling Mantel, W32RO Mantel and Base