1.Lay right side panel (#2) face down on a soft surface to avoid marking finish. Attach four brackets with 1/2" screws to bottom of right front leg (#3) leaving screws slightly loose. Face brackets out (see Figure 1). Place right front leg (#3) over right side (#2) as shown in Figure
2, paying close attention to direction arrow pointing up on panels. Align threaded holes with brackets on side.
Start four 1/2" screws through brackets. Align bottom of side and leg assembly so they are flush with each other.
Hold these pieces securely in alignment while tightening
(but not over tightening) screws.
2.Assemble left side (#4) and left leg (#5) as described in step 1.
3.Attach 6 brackets to base (#1) at threaded hole locations using 1/2" screws leaving screws loose. Face brackets toward outside (see Figure 2).
4.Place right side/leg assembly on base and align threaded holes with brackets. Start 1/2" screws through brackets into threaded holes in side/leg assembly. Back of side/ leg assembly should be flush with back of base. Assure alignment is correct and spaces are at a minimum and tighten leaving screws slightly loose.
5.Assemble left side/leg assembly to base (#1) following step #4.
Header Assembly
Position header (#6) between leg assemblies onto shoul- ders with direction arrow pointing up. Align threaded holes in header with holes in leg assembly (see Figure 4). Attach header (#4) with four 1 1⁄4" screws and washers (see Figure 4). Hold header in proper alignment with leg assemblies and tighten, leaving screws slightly loose.
Right Front Leg
1/2" Screws
Right Side
Figure 1 - Attaching Front Leg
Right
Side/Leg
Assembly 
Bracket | Base (#1) |
|
1/2" Screw 
Figure 2 - Leg Assembly to Base
Header
Shoulder
Left Leg | Right Leg |
Assembly | |
Assembly |
|
Figure 3 - Installing Header
Header
Leg
WasherAssembly
1 1/4" Screw
Figure 4 - Attaching Header to Leg Assembly
2 | www.desatech.com |
