Desa MN10T, MP10T, WMN10, WMP10 9

Installation

Continued

INSTALLING HEATER TO WALL

Marking Screw Locations

1. Determine where you will locate heater.

WARNING: Maintain minimum clearancesshowninFigure

5.If you can, provide greater clearances from floor and join- ing wall.

2.Mark two mounting screw locations on wall (see Figure 5).

10 7/8" 7 3/4"

Minimum

3.Insert wall anchor (wings first) into hole. Tap anchor flush to wall.

4.For thin walls (1/2" or less), insert red key into wall anchor. Push red key to “pop” open anchor wings (see Figure 7).

IMPORTANT: Do not hammer key! For thick walls (over 1/2" thick) or solid walls, do not pop open wings.

5.Tighten two screws until 1/16" space (thickness of penny) is between screw heads and wall (see Figure 8).

FLOOR

Figure 5 - Mounting Screw Locations

Installing Two Mounting Screws

Note: Wall anchors and mounting screws are in hardware package. The hardware package is provided with heater.

Attaching to Wall Stud Method

For attaching mounting screw to wall stud

1.Drill hole at marked location using 9/64" drill bit.

2.Insert mounting screw into wall stud.

3.Tighten screw until 1/16" space (thickness of penny) is between screw head and wall.

Attaching to Wall Anchor Method

Figure 6 - Folding Anchor

Figure 7 - Popping Open Anchor Wings

For Thin Walls

Figure 8 - Tightening Anchors

Placing Heater On Mounting Screws

1.Locate two keyhole slots on back panel of heater (see Figure 9).

2.Place large openings of slots over screw heads. Slide heater down until screws are in small portion of slots.

Follow instructions below to attach mounting screws to hollow walls (wall areas between studs) or solid walls (concrete or masonry).

1.Drill holes at marked locations using 5/16" drill bit. For solid walls (concrete or masonry), drill at least 1 1/4" deep.

2.Fold wall anchor (see Figure 6).

Keyhole Slots

Figure 9 - Location Of Keyhole Slots On

Back Panel Of Heater

123995-01C