22
CLEANING AND MAINTENANCE
Cleaning Burner Injector Holder and Pilot Air Inlet Hole (Cont.)
Logs
Main Burner
WIRING DIAGRAM
SPECIFICATIONS
CLEANING AND
MAINTENANCE
Continued
5.Blow air into the primary air holes on the injector holder.
6.In case any large clumps of dust have now been pushed into the burner repeat steps 3 and 4, page 21.
Clean the pilot assembly also. A yellow tip on the pilot flame indicates dust and dirt in the pilot assembly. There is a small pilot air inlet hole about two inches from where the pilot flame comes out of the pilot assembly (see Figure 48). With the unit off, lightly blow air through the air inlet hole. You may blow through a drinking straw if compressed air is not available.
Ports/Slots
Burner
Tube
Pilot
Assembly
Pilot Air
Inlet Hole
Figure 48 - Pilot Inlet Air Hole
LOGS
•If you remove logs for cleaning, refer to Installing Logs, pages 15 and 16, to properly replace logs.
•Replace log(s) if broken or chipped
MAIN BURNER
Periodically inspect all burner flame holes with the fireplace run- ning. All slotted burner flame holes should be open with yellow flame present. All round burner flame holes should be open with a small blue flame present. Some burner flame holes may become blocked by debris or rust, with no flame present. If so, turn off fireplace and let cool. Remove blockage, blocked burner flame holes will create soot.
WIRING DIAGRAM
Note: For proper operation of optional accessories, the wires from the switch to the control must be connected exactly as shown.
A |
|
UT | |
O | |
OF | |
ON | F |
|
Thermopile
SPECIFICATIONS
| VYGF33NRB |
| FPVF33NRA |
Btu (Variable) | 20,000/30,000 |
Type Gas | Natural Gas Only |
Ignition | Piezo |
Pressure Manifold | 3.5" W.C. |
Inlet Gas Pressure (in. of water) |
|
Maximum | 10.5" |
Minimum* | 5" |
Shipping Weight | 122 lbs. |
* For input adjustment |
|
| VYGF33PRB |
| FPVF33PRA |
Btu (Variable) | 20,000/33,000 |
Type Gas | Propane/LP Only |
Ignition | Piezo |
Pressure Manifold | 8.0" W.C. |
Inlet Gas Pressure (in. of water) |
|
Maximum | 14" |
Minimum* | 11" |
Shipping Weight | 122 lbs. |
* For input adjustment |
|
For..com