Desa Tech CGP10 installation manual TROUBLE- Shooting, Low

TROUBLE- SHOOTING

Continued

OBSERVED	POSSIBLE
PROBLEM	CAUSE		REMEDY
Burner does not light	1.	Burner orifice is	1.	Clean burner orifice (see
after ODS/pilot is lit		clogged		Cleaning and Mainte-
				nance, page 20) or replace
				burner orifice
	2.	Burner orifice diameter	2.	Replace burner orifice
		is too small
	3.	Inlet gas pressure is	3.	Contact local propane gas
		too low		company

Delayed ignition of 1.	Manifold pressure is
burner	too low
2.	Burner orifice is
	clogged

1.Contact local propane gas company

2.Clean burner orifice (see Cleaning and Mainte- nance, page 20) or replace burner orifice

Burner backfiring dur- 1.	Burner orifice is
ing combustion	clogged or damaged
2.	Burner damaged
3.	Gas regulator defective

1.Clean burner orifice (see Cleaning and Mainte- nance, page 20) or replace burner orifice

2.Replace burner

3.Replace gas regulator

22

Yellow	flame during	1.	Not enough air	1.	Check burner for dirt and
burner combustion					debris. If		found, clean
					burner (see Cleaning and
					Maintenance, page 20)
		2.	Gas regulator defective	2.	Replace gas regulator
Slight smoke or odor		1.	Residues from manu-	1.	Problem will stop after a
during	initial opera-		facturing processes		few hours of operation
tion
Heater	produces a	1.	Turning control knob	1.	Turn	control		knob	to
whistling noise when			to HIGH position		LOW	position		and	let
burner is lit			when burner is cold		warm up for a minute
		2.	Air in gas line	2.	Operate burner until air is
					removed from line. Have
					gas checked by local pro-
					pane gas company
		3.	Air passageways on	3.	Observe minimum instal-
			heater blocked		lation	clearances (see
					Figure 4, page 10)
		4.	Dirty or partially	4.	Clean burner (see Clean-
			clogged burner orifice		ing and Maintenance,
					page	20)	or	replace
					burner orifice

099403