INSTALLATION

Continued

2.Open main gas valve located on or near gas meter for natural gas or open pro- pane/LP supply tank valve.

3.Make sure control knob of heater is in the OFF position.

4.Check all joints from equipment shutoff valve to thermostat gas valve (Ther- mostat-Controlled Models) or to control valve (Manually-Controlled Models) (see Figures 17 and 18). Apply noncorrosive leak detection fluid to all joints. Bubbles forming show a leak.

5.Correct all leaks at once.

6.Light heater (see Operation, page 19 [manually-controlled models] or page 21 [thermostatically-controlled models]). Check all other internal joints for leaks.

7.Turn off heater (see To Turn Off Gas to Appliance, page 20 [manually-controlled models] or page 22 [thermostatically- controlled models]).

Propane/LP

Equipment

Supply Tank

Shutoff Valve

Thermostat Gas Valve or Control Valve Location

Figure 17 - Checking Gas Joints

(Propane/LP Gas Models)

Equipment

Shutoff Valve

Gas Meter

Thermostat Gas Valve or Control Valve Location

Figure 18 - Checking Gas Joints (Natural

Gas Models)

INSTALLING LOGS

CAUTION: After installation and periodically thereafter, check to ensure that no flame comes in contact with any log. With the heater set to HI, check toseeifflamescontactanylog.If so, reposition logs according to the log installation instructions in this manual. Flames contacting logs will create soot.

WARNING:Failuretoposition thepartsinaccordancewiththese diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.

Dual Burner Biltmore Split Oak Models CCL3018PTA/NTA, CCL3924PTA/NTA Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.

1.Place front log (#1) on grate fingers. Make sure front log rests firmly between grate fingers and grate base (see Figure 19).

2.Place base of middle log (#2) in U-shaped slots of grate base. Cutout on right of middle log should fit over burner (see Fig- ure 20, page 17). Make sure front of middle log is resting on tabs of grate base.

Front

Log (#1)

Grate

Fingers

Grate

Base

Figure 19 - Installing Front Log #1

(CCL3924PTA/NTA Shown)

16

www.desatech.com

113097-01L