INSTALLATION
Continued
3.Locate pins on bottom of back log (#3). Slide these pins into holes in grate base behind burner (see Figure 21).
4.Locate holes on bottom of crossover log (#4). Slide front hole onto left pin (CCL3924PTA/ NTA) or middle pin (CCL3018PTA/NTA) on middle log (#2) and pin on back log (#3).
See Figure 22, for placement.
5.For CCL3924PTA/NTA Only: Locate pin and hole on bottom of crossover log (#5). Slide pin into hole located in crossover log (#4). Slide hole onto pin on front log (#1). See Figure 23.
For CCL3018PTA/NTA Only: Locate holes on bottom of crossover log (#5). Slide holes over left pins on middle log (#2) and front log (#1). See Figure 24.
6.Locate holes on bottom of crossover log (#6). Slide these holes onto right pins locat- ed in middle log (#2) and front log (#1). See
Figure 25, page 18 for CCL3924PTA/NTA.
See Figure 24 for CCL3018PTA/NTA.
7.Add lava rock around base of heater if desired. Do not place any lava rock on logs or burner.
| Crossover |
Pins | Log (#4) |
Middle
Log (#2) 
Back Log
(#3)
Middle | Figure 22 - Installing Crossover Log #4 |
Log (#2) | (CCL3924PTA/NTA Shown) |
| Crossover |
| Log (#5) |
| Crossover |
| Log (#4) |
Burner |
|
Tab | Front Log (#1) |
|
| |
|
|
| ||
Figure 20 - Installing Middle Log #2 | Figure 23 - Installing Crossover Log #5 | |||
(CCL3924PTA/NTA Shown) | ||||
|
| (CCL3924PTA/NTA Shown) | ||
| Pins | Crossover | Crossover | Crossover |
|
| |||
|
| Log (#4) | Log (#6) | |
|
| Log (#5) | ||
| Rear |
|
| |
| Middle |
|
| |
| Log (#3) |
|
| |
|
| Log (#2) |
|
|
| Hole in |
|
|
|
| Grate Base |
|
|
|
| Burner |
|
|
|
|
| Front |
|
|
|
| Log (#1) |
| |
Figure 21 - Installing Rear Log #3 | Figure 24 - Installing Crossover Log #5 | |||
(CCL3924PTA/NTA Shown) | and Log #6 (CCL3018PTA/NTA Only) | |||
www.desatech.com | 17 |