INSTALLATION | Back Log | |
Continued | Post | |
| ||
Crossover | Base | |
Assembly | ||
Log (#6) | ||
|
| Pins |
| Middle |
Front | Log (#2) |
Log (#1) |
|
Figure 25 - Installing Crossover Log #6
(CCL3924PTA/NTA Shown)
Single Burner Seasonal Oak Models
CRL2718PA/NA, CRL3124PA/NA
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
The Seasonal Oak Log Set is a reversible log set. This means that the 2 bottom logs may be turned to face either direction. The top logs, however, must remain in the same position. Do not modify logs. Only use logs supplied with heater.
1.Place back log onto back of base assembly.
Make sure log sits forward against 2 posts in front of log (see Figure 26). This log may be turned to face either direction.
2.Place front log onto grate on front of base assembly. The log will fit down between grate fingers and posts on front of base assembly (see Figure 27). This log may be turned to face either direction.
3.Place left and right crossover logs on top of back log and front log. Make sure pins on front and back are inserted into holes on crossover logs (see Figure 28). Crossover logs must be placed as shown in Figure 28 or holes will not seat onto pins.
4.Add lava rock around base of heater if desired. Do not put lava rock on logs or burner.
Post
Figure 26 - Installing Back Log
Front Log
Post
Grate |
|
Fingers Base | Post |
Assembly |
|
Figure 27 - Installing Front Log | |
Left Crossover Log | Right |
| |
| Crossover Log |
Figure 28 - Installing Left and Right
Crossover Logs
18 | www.desatech.com |