WARNING: Procedures and techniques, which, if not carefully followed, will expose the user to the risk of serious injury, illness or death.
WARNING: Procedures and techniques, which, if not carefully followed, will result in damage to the equipment or personal property or may cause personal injury.
WARNING: This is a 1500 watt heater and parts become hot when in use. Be sure to maintain a personal distance and keep any combustible material at least three (3) feet away from
the front of the heater. The area directly behind, around and under the heater must be clear and free of any obstructions.
KEEP CHILDREN AND PETS AWAY FROM HEATER AND CONTROLS
LOCATING YOUR ELECTRIC FIREPLACE
Your new freestanding electric fireplace may be installed virtually anywhere in your home. However, when choosing a location for your new electric fireplace, ensure that the general instructions are followed. For best results, install the electric fireplace out of direct sunlight.
CLEARANCE TO COMBUSTIBLES | ELECTRICAL SPECIFICATIONS | ||
Back………….…0"/0mm | Voltage | 120 VAC/60Hz | |
Sides……………0"/0mm | Total Amps | 11.3 Amps | |
Floor…….………0"/0mm | Total Watts | 1500 Watts | |
Top…….........….24"/610mm | Heater Ratings | 1400 Watts (+5%, | |
Front | ..................36”/915mm |
|
|
ELECTRICAL CONNECTION
A 15 AMP, 120 Volt, 60Hz circuit with a properly grounded outlet is required. Preferably, the heater will be on a dedicated circuit. Other appliances on the same circuit may cause the circuit breaker to trip or the fuse to blow when the heater is in operation. The unit comes standard with a 6' (1828mm) long three wire cord exiting from the rear of the fireplace. Plan the installation to avoid the use of an extension cord. If an extension cord must be used, it must be a minimum 16 AWG three wire with grounding type plug connector and rated no less than 1900 Watts.
WARNING: Electrical
outlet wiring must comply with local building codes and all other applicable regulations to reduce the risk of fire, electrical shock and injury.
WARNING: Do not use this fireplace if any part of it has been under water. Immediately call a qualified service technician to inspect the fireplace and replace any part of the electrical system if necessary.
