INSTALLATION
Continued
12.Using the four screws previously removed, mount blower assembly to stove by reattach- ing blower brackets to rear panel (see Fig- ure 16). Tighten screws securely.
13.Install plastic control knob onto output shaft of speed control housing (see Figure 17). Place speed control housing just inside control com- partment door in front of stove (see Figure 17).
14.Using two screws provided in blower kit, mount blower speed control housing to mount- ing tab in left side of lower control compart- ment (see Figure 18).
15.Check to make sure that the power cord is completely clear of blower wheel and there are no foreign objects in blower wheel.
16.Carefully replace stove top panel. Align holes and replace six screws removed in step 1, page 12.
17.Peel off the backing paper and stick the sup- plied wiring diagram decal on the stove floor as shown in Figure 18.
18.Plug power cord into a convenient
WARNING: Electrical Grounding Instructions:Thisap- pliance is equipped with a three- prong (grounding) plug for your protection against shock hazard
Blower | Blower Bracket |
Firebox
Top 
Figure 16 - Removing Blower Brackets |
from Stove and Attaching to Blower |
Blower Speed
Control Housing
Figure 17 - Installing Blower Control
Housing
and should be plugged directly into a properly grounded three- prong receptacle.
19.Using speed control knob, turn blower on and check for operation.
20.All remaining parts from blower kit may be discarded.
Power
Cord
Control Speed
Knob Control
Housing
WARNING: Never attempt to ser- vice heater while it is plugged in, op- erating, or hot. Burns and electrical shock could result. Only a qualified service person should service or re- pair heater.
If any of the original wire as supplied with the appliance must be replaced, it must be replaced with 105°C wire or it’s equivalent.
WARNING: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous opera- tion. Verify proper operation after servicing.
120 Vac. |
| Variable | ||||||
Fan Switch | ||||||||
60 Hz. . |
|
|
|
| ||||
78 Amps |
|
|
|
| ||||
Off | On | |||||||
|
| V.A.C. | ||||||
|
| Black Black |
| Motor | ||||
110/115 |
|
|
| Blower | ||||
|
|
| Black |
|
|
| Black | |
|
|
| Green |
|
|
|
| |
|
|
| White |
|
|
| White | |
DESA Heating Products, Bowling Green, KY
Wiring Diagram Decal
Figure 18 - Routing Power Cord
www.desatech.com | 13 |
