OWNER’S MANUAL
INSTALLATION
Continued
9.Fasten stove bottom to stove with four
(4) M6 x 1 - 25mm bolts. Use a flat washer and lock washer with each bolt. Tighten bolts into threaded holes on stove body (see Figure 8, page 8 and 10). Use an adjustable wrench or a 10mm socket.
10.Attach stove door by inserting step bolt through door hinge pivot holes and into threaded hole in stove body (see Fig- ure 11). Use an adjustable wrench or a 12mm socket to fasten step bolt. Tighten step bolt until snug. Make sure door moves freely.
11.Install door catch bolt (M8 x 1.25- 55mm with two M8 hex nuts) into threaded hole on stove body (see Fig- ure 8, page 8). Use an adjustable wrench or a 12mm socket. The catch bolt has two hex nuts attached to it (see Figure 12). The top nut is a bolt stop and the bottom nut is for door leveling adjustment.
12.Check general catch bolt alignment with door claw. Make final adjustment and door leveling after stove is in nor- mal standing position.
13.Carefully lift stove back up on its four attached legs.
14.If available, install gas log heater in- side stove cavity before installing the back panel (see Installing Gas Log Heater Into Stove, page 10).
15.Fasten back panel to stove with six (6) M6 x 1 - 20mm bolts and washers. Make sure product identification label is located on the outside in lower left- hand corner.
Washers 
Bolt | Bolt | Bottom Of |
| ||
| Stove Unit | |
Bottom Of |
| |
| Stove | |
Stove Unit |
| |
| Bottom | |
Leg |
| |
Figure 9 - Attaching Stove Legs | Figure 10 - Attaching Stove Bottom | |
Stove | Stove | |
Door | Door | |
Threaded | Bolt | |
Hole | Shoulder | |
Door | Door | |
Hinge | ||
Hinge | ||
|
Step | Step | |
Bolt | ||
Bolt | ||
| ||
Bolt | Stove Bottom | |
Shoulder |
|
Figure 11 - Attaching Stove Door (Appearance May Vary Depending on Model)
Bolt Stop
Adjusting Nut
Door | Door Claw |
Catch Bolt
Figure 12 - Catch Bolt and Door Claw Orientation
Continued
104464 | 9 |
