www.fmiproducts.com
116986-01H 17
oPeRaTIoN
Continued
Shut Off Procedure
To save battery power, press to turn main
gas to pilot gas. Press the OFF button to
shut off the device including pilot ame. The
device can be shut off with ON/OFF switch,
thus disabling remote hand set.
Setting Display ( °C/24h and °F /12h)
Press and hold OFF and until display
changes from °F (and 12 hour clock) to °C
(and 24 hour clock) or vice versa.
Setting The Time
• After connecting battery or by simultane-
ously pressing and the display will
start to ash. You are in the set mode.
• From SET mode press to set the hour
and to set the minute.
�� Wait or press OFF to return to manual
mode.
Battery Replacement
Remote handset battery needs to be changed
when LED is dim. Battery life expectancy is
2 to 3 years. Replacement is recommended
at the beginning of heating season. Battery
needs to be changed when acoustic error
message appears during ignition (see Identify-
ing Error Signals from Receiver, page 24).
Changing Mode of Operation
• Press the SET button quickly to change the
mode of operation in the following order:
MAN, TEMP, TEMP, TIMER.
• Manual ame height adjustment (MAN ap-
pears on display): Press to turn on the
re (main burner) or to increase ame height.
Press to decrease ame or to go down
to pilot only. The receiver acknowledges the
transmission with an acoustic signal.
• The day time temperature mode ( TEMP
appears on display): The sensor in the
transmitter measures room temperature.
The controller compares the room tem-
perature with set temperature and sends
a signal to the receiver to turn gas valve
motor up or down, to adjust ame height
accordingly.
• The nighttime setback temperature (
TEMP appears on display): The sensor in
the transmitter measures the temperature
and adjusts it according to the nighttime
setback temperature. There is a bigger
temperature differential during this cycle.
• Timer: The timer mode (TIMER) operates
much like the temperature mode above.
The timer setting allows you to set specic
times for on and off. (There are 2 burner
on and 2 burner off cycles every 24 hours.)
If the reading for the nighttime temp. is
"– – –", the motor will turn off the valve to
standby pilot position and wait for the next
burner on cycle. This display shows the
setting temperature every 30 seconds.
Setting Temperature
• Select the desired mode of operation
(day or night) by pressing the SET button
briey.
• Hold SET button until display ashes.
• Set temperature with the or (40°F is
the minimum temperature).
• Wait or press OFF to go to temperature
control mode.
• If temperature control in moon times
should be off (lower battery consumption),
decrease night temperature until "– – –"
appears on display.
Set Timer
• Switch to timer mode by pressing the SET
button briey.
• Press the SET button until P1 ashes.
• Set hours with and minutes with .
• Press SET briey for the next burner cycle
time.
• If all 4 times are set, pressing the OFF but-
ton or waiting will complete programming.
Shutting Off Heater
Press OFF button on remote control to switch
off main gas and pilot gas.
Shutting Off Burner Only (pilot stays lit)
Press to decrease the ame height and
shut off main burner.
SET
OFF
STAND
BY
Figure 18 - Control Panel for Hand-Held
Remote