DeVillbiss Air Power Company A16064, DVH2600 Trouble Shooting Guide, Problème Cause Correction

TROUBLE SHOOTING GUIDE

PROBLÈME	CAUSE	CORRECTION
Engine will	No fuel.	Add Fuel.
not start (see
	Pressure builds up after two	Squeeze gun trigger to relieve
Engine Manual
	pulls on the recoil starter or	pressure.
for further
engine trouble-	after initial use.
shooting)	Choke lever in the "No	Move choke to the "Choke"
	Choke" position.	position.
	Spark plug wire not	Attach spark plug wire.
	attached.
	Engine ON/OFF switch in	Place engine ON/OFF switch
	OFF position.	in ON position.
	Choke lever in the "Choke"	Move choke to the "No
	position on a "hot" engine	Choke" position.
	or an engine that has been
	exposed to thermal heat for
	a long period of time.
	Fuel valve closed	Move the fuel valve lever to
		the "Open" position.
No or low	Spray wand not in high	See How to Use Spray Wand
pressure	pressure.	instructions in the Operation
(initial use)		Section.
	Low water supply.	Water supply must be at least
		5 GPM @ 20 PSI (137.9 kPa).
	Leak at high pressure hose	Repair leak. Apply sealant
	fitting.	tape if necessary.
	Nozzle obstructed.	See Nozzle Cleaning
		instructions in the
		Maintenance section.
	Water filter screen clogged.	Remove and clean filter.
	Air in hose.	Turn off the engine, then the
		water source. Disconnect the
		water source from the pump
		inlet and turn the water source
		on to remove all air from the
		hose. When there is a steady
		stream of water present, turn
		water source off. Re-connect
		water source to pump inlet
		and turn on water source.
		Squeeze trigger to remove
		remaining air
	Choke lever in the "Choke"	Move choke to the "No
	position.	Choke" position.
	High pressure hose is too	Use high pressure hose under
	long.	100 feet.

A16064 16- ENG