DeVillbiss Air Power Company D25572 warranty To Start The Engine, Recoil start/Pull start

Engine speed has been factory set to provide safe operation. Tampering with the engine speed adjustment could result in over-

heating of attachments and could cause a fire. Never attempt to “speed-up” the en- gine to obtain more performance. Both the output voltage and frequency will be thrown out of standard by this practice, endangering attachments and the user.

You MUST unplug any load from the generator before starting to prevent permanent damage to any appliances.

TO START THE ENGINE

(Recoil start/Pull start)

Never run engine indoors or in enclosed, poor ventilated areas, engine exhaust contains carbon monoxide, an

odorless and deadly gas.

1.Open the fuel shut-off valve. Turn counter clockwise until the valve stops. See Figure 8.

2.(if equipped) On the engine there is a ON/OFF switch located on the front panel of the engine. Place this switch to the "ON" position.

OR

Figure 8

3.Move the choke control located on the engine to "CHOKE" position. NOTE: No choke is required on warm engines. Make sure choke is in the "RUN" position on warm engine starts.

4.Grasp handle on rope starter and pull slowly until resistance is felt. Let the rope rewind slowly. Pull rope with a rapid full arm stroke. Let rope rewind slowly. Repeat if necessary.

NOTE: IF ENGINE OIL LEVEL IS TOO LOW, ENGINE WILL NOT START. CHECK OIL LEVEL AND ADD IF NECESSARY.

5.When engine starts, gradually move the choke to the "RUN" position. IMPORTANT: Allow generator to run at no load for 5 minutes upon each initial start-up to allow engine and generator to stabilize.

TO START GENERATOR (Electric start)

1.Open the fuel shut-off valve. See Figure 8.

2.(if equipped) On the engine there is a ON/OFF switch located on the front panel of the engine. Place this switch to the "ON" position.

3.Move the choke control located on the engine to "CHOKE" position. A cold engine may require to be choked longer than a warm engine.

4.Push ON\OFF\START switch on control panel to the "START" position to start engine. Hold in "START" position no longer than 15 seconds per minute when trying to start engine. Extended cranking can damage the starter motor.

5.When engine starts, gradually move the choke to the "NO Choke" position.

IMPORTANT: Allow generator to run at no load for 5 minutes upon each initial start-up to allow engine and generator to stabilize.

13- ENG D25572