GLOSSARY
GFCI: (GROUND FAULT CIRCUIT INTERRUPTER) This pressure washer is equipped with a GFCI built into the plug of the power supply cord. This device provides additional protection from the risk of electrical shock. (Figure 1)
FLOW RATE: This is the amount of water that passes through your wand. (Usually measured in G.P.M., gallons per minute.).
IDLE MODE: This pertains to the time that the pressure washer is running without the trigger on the wand en- gaged to spray. You should never run this pressure washer for more than 5 minutes without pulling the trigger to relieve pressure. Running the pressure washer in this manner would void your warranty.
Operating unit with water supply shut off (without flow of water) will result in equipment damage.
KICK START: There is a tendancy on new units or units that have not been used for awhile for the motor to "Hum" briefly on
This is done by disconnecting the power cord and turning the motor shaft by inserting a large blade straight slot screw driver into the slot located in the shaft at the rear of the unit (Figure 2). Turn the shaft two or three times to free any seals that might be stuck.
RESET |
|
| ||
|
|
| ||
P | USH "RESET" ON |
|
|
|
|
|
|
|
|
| GFCI |
|
| |
| Figure 1 |
| Figure 2 |
GROUNDING INSTRUCTIONS & EXTENSION CORDS
GROUNDING: This product must be grounded. If it should malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. This product is equipped with a cord having an equip-
Improper connection of the
GROUND FAULT CIRCUIT INTERRUPTER PROTECTION: This washer is provided with a ground fault circuit interrupter (GFCI) built into the plug of the power supply cord. This device provides additional protection from the risk of electric shock. Should replacement of the plug or cord become necessary, use only identical replacement parts that include GFCI protection.
EXTENSION CORDS: Extension cords are NOT recom- mended to be used with product. If an extension cord must be used, the following 3 requirements should be met:
1.14 guage minimum wire size up to 25 ft. cord.
2.12 guage minimum wire size up to 50 ft. cord.
3.Use only
To reduce the risk of electrocution, keep all connections dry and off the ground. Do not touch plug with wet hands. Do not use if cord is damaged.
6