DeWalt 50-665 instruction manual Assembly, J Fig

ASSEMBLY

1.Place gasket (A) Fig. 3, on bottom of motor and blower assembly (B). Align four holes in gasket with holes in motor and blower assembly and assemble cover

(C) Fig. 3, to gasket and motor and blower assembly with four hex head screws, flat washers, lockwashers, and locknuts (D).

2.Fig. 4, illustrates the cover (C) assembled to the underside of motor and blower assembly (B).

3.Peel the adhesive paper (E) Fig. 5, from the back of the gasket material (F) and press the gasket material around the underside of the dust collector cover (C). Cut off any excess gasket material.

4.Carefully turn the assembly over. Place gasket (G) Fig. 6, over two holes in cover (C) and secure upper inlet

elbow (H) to cover with two 3/8-16 x 1-1/4 hex head screws and flat washers (J), as shown in Fig. 7.

C

F

E

Fig. 5

B

C A

D

Fig. 3

C

B

Fig. 4

C

G

H

JJ J Fig. 6

6