5.Position the remaining inlet elbow (K) Fig. 8, at the underside of dust collector lid (C) as shown. Align the mounting holes in inlet elbows (K) Fig. 8, with screws (J) assembled to upper inlet elbow (H) shown in Fig. 7, STEP 4, and fasten the upper and lower inlet elbows to the cover with remaining two flat washers, lockwashers, and locknuts(J) Figs. 7 and 8.
6.Place the sheet metal cylinder (L) Fig. 9, onto the underside of the cover.Align four holes in cylinder brack- et, three of which are shown at (M), with four holes (N) in the underside of cover and fasten with four
7.Assemble safety grid (V) Fig. 11, over metal cylinder
(L) and fasten grid to cylinder with three pan head screws
(W) as shown in Fig. 12.
P
L
P
Fig. 10
J
Fig. 7
H
C 
J
K
Fig. 8
N
L
M
M N
Fig. 9
V
L
Fig. 11
7
