English
5.When the paint softens, scrape the paint away using a hand scraper.
REMEMBER: Splinters and small particles of stripped paint can be ignited and blown through holes and cracks in the surface being stripped.
Stationary Use (Fig. 1)
This tool can also be used in stationary mode.
1.Fold down the kickstand (C) as shown in Figure 1.
2.Set the tool onto a level, stable workbench. Ensure the tool will not tip over.
3.Secure the power cord to prevent entanglement or pulling the tool off the workbench.
4.Turn the tool on by selecting the desired air flow.
Constant Heat Control (overload protection)
When the tool is overloaded, this feature protects the heating element from damage without stopping the tool and/or without a cool down period
1.When the temperature gets too hot, the heating element switches itself off. The motor will continue to run and produce cold air.
2.When the temperature has cooled sufficiently (taking only a few seconds) the heating element will switch on automatically.
Tool Ring (Fig. 1)
WARNING: ALWAYS turn heat gun off, disconnect from the power source and let the tool cool down for at least 30 minutes before moving or storing it.
For easy storage, the tool can hang from the tool ring (F). The heat gun should be stored indoors.
Cool Down Period
The nozzle and accessory becomes very hot during use. Turn heat gun off, disconnect from the power source and let the tool cool down for at least 30 minutes before moving or storing it.
NOTE: To reduce the cooling time, switch the tool on at the lowest air temperature setting and let it run for a few minutes before turning the heat gun off.
MAINTENANCE
WARNING: To reduce the risk of injury, turn unit off and disconnect tool from power source before installing and removing accessories, before making any adjustments or removing/installing attachments or accessories.
Your DEWALT power tool has been designed to operate over a long period of time with a minimum of maintenance. Continuous satisfactory operation depends upon proper tool care and regular cleaning.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of the main housing with dry air as often as dirt is seen collecting in and around the air vents. Wear approved eye protection and approved dust mask when performing this procedure.
WARNING: Never use solvents or other harsh chemicals for cleaning the
8
