DeWalt DW705 manual Outside Corner, Proper CUT Improper CUT

English

2. Save left side of cut Right side

1.Miter Right 45°

2.Save right side of cut

OUTSIDE CORNER:

Left side

1.Miter right at 45°

2.Save left side of cut

Right side

1.Miter left at 45°

2.Save right side of cut

Material up to 3.9" (3-7/8)" can be cut as described above. For wider boards [up to 5.5" (5-1/2")] several minor concessions must be made.

When cutting a board between 3.9" (3-7/8") and 5.5" (5-1/2") in width the roller on the tip of the guard will hang up on the workpiece. If this occurs, simply place your right thumb on the upper side of the guard and roll the guard up just enough to clear the workpiece, as shown in Figure 25. Once you have cleared the workpiece, you can release the guard and it will continue to open as the cut progresses.

When mitering to the right side of a base molding wider than 3.9" (3-7/8") standing vertically against the fence as in Figure 22, the saw can only cut through the board up to 1 inch from the end of the board. Trying to cut more than an inch will cause the saw’s gear case to interfere with the workpiece. If you want to cut base molding between 3-7/8" and 5-1/2" wide vertically follow the directions on next page.

CUTTING 3-7/8"– 5-1/2" BASE MOLDING VERTICALLY AGAINST THE FENCE

FIG. 16

PROPER CUT

IMPROPER CUT

•Position molding as shown in Figure 22

•All cuts made with the back of the molding against the fence

INSIDE CORNER: Left side

1.Position molding with bottom of molding against the base of the saw

2.Miter left 45°

3.Save left side of cut

Right side

1.Position molding with top of the molding resting on the base of the saw

2.Miter left 45°

3.Save left side of cut

OUTSIDE CORNER:

Left side

		FENCE
	ADJUST	USE
ALWAYS	BEFORE
PROPERLY

ANGERAWAAYDE
D	KEEOPMBL
	FR

ER

NG

DA

DJUST￿FENCE

ALWAYS￿APROPERLY￿BEFORE￿US

GER
N	AY
DA KFEEROPMAWBLADE

ER NG DA

1.Position molding with bottom of molding against the base of the saw

2.Miter right 45°

3.Save left side of cut

PROPER CUT

IMPROPER CUT

10