2.Depress the leg release lever (F) with the other hand then push the leg under the beam on the stand. Repeat the operation on the second leg of the stand and rest the stand on wheels.

K

L

M

F

3.Repeat with the other end of the stand.

4.Pull the extendable handle (K) out of the side of the stand. The spring-loaded handle lock (L) will lock the handle into position for transporting the saw on the stand. Pull the handle lock down to release the handle and then slide the handle in for storage.

WARNING: To reduce the risk of personal injury, DO NOT operate the table saw mounted to the stand with the legs folded and the stand sitting on the ground.

To Raise Stand from Collapsed Position

Roll the stand to the workspace. Be sure the area is flat and stable before attempting to set up the saw and stand.

1.Tilt up the stand until the saw is at a 45 degree angle.

2.Depress the leg release levers one at a time to release the locking pins and pull the front legs out until each locking pin clicks into the detent.

WARNING: Be sure that the locking pins have engaged and the legs are firmly held in place.

3.Rest the stand on the legs.

4.Depress the handle lock to release the handle. Slide the handle into the leg support for storage as you work.

5.Go to the opposite side of the stand and grasp the saw under the rear axle. Lift the saw and stand.

6.Reach under the stand and, one at a time, depress the leg release levers to release the locking pins. Pull out the remaining two legs. Be sure that the locking pins have engaged and the legs are firmly held in place. Rest the stand on the ground.

Accessories

WARNING: Since accessories, other than those offered by DEWALT, have not been tested with this product, use of such accessories with this tool could be hazardous. To reduce the risk of serious injury, place stand on flat, stable surface. DO NOT create unstable conditions.

Recommended accessories for use with your tool are available at extra cost from your local dealer or authorized service center. If you need assistance in locating any accessory, please contact DEWALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD 21286, call 1-800-4-DEWALT (1-800-433-9258) or visit our website www. dewalt.com.

Repairs

To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustments should be performed by a DEWALT factory service center, a DEWALT authorized service center or other qualified service personnel. Always use identical replacement parts.

English

6

Page 7
Image 7
DeWalt DW7440RS instruction manual To Raise Stand from Collapsed Position, Accessories Repairs