Table Saw Bracket Mounting
WARNING: To reduce the risk of injury, turn unit off, disconnect machine from power source before assembling the table saw to the table saw stand. An accidental
cause injury.
WARNING: For your own safety, read and understand the table saw instruction manual before using. Failure to heed these warnings may result in personal injury and serious damage to the table saw and the accessory.
WARNING: The saw mounting brackets provided with this stand are equipped with lever locks. To reduce the risk of injury, DO NOT
modify the mounting bracket lever locks. | G | ||||||
1. Unfold the legs by depressing | R | ||||||
the leg release levers (F). |
| ||||||
Rotate the legs until the | H | ||||||
locking pin (G) clicks into its | |||||||
detent (R). |
|
|
|
| F | ||
|
|
|
|
| |||
2. Turn the stand upright. The |
| ||||||
stand should be stable and |
| ||||||
should not rock. |
|
|
|
| |||
WARNING: Be sure that |
| ||||||
the | locking | pins | have | E | |||
engaged |
| and | the | legs | |||
|
| ||||||
are firmly held in place. |
|
| |||||
3. The | locator | clip | (J) |
| |||
keeps the saw from sliding |
| ||||||
left or right during cutting |
| ||||||
operations | and | during |
| ||||
transport. Install the mounting |
| ||||||
brackets on to the beam as | J | ||||||
shown | by | engaging | the | ||||
concave | front | lip | of | the |
| ||
mounting bracket with the |
| |||
rounded front edge of the |
| |||
beam.One of the brackets |
| |||
must engage the locator |
| |||
clip (J). The mounting |
| |||
bracket release | levers |
| ||
(E) must be positioned to | D | |||
the rear of the stand as | ||||
shown. |
|
|
|
|
4. Measure | the | distance |
| |
between | the | mounting |
| |
holes of | the | table saw. | E | |
Position | the |
| second |
|
mounting | bracket onto |
| ||
the beam at this distance |
| |||
from the | first | mounting |
| |
bracket. |
|
|
|
|
5. Align the | holes | in the | table | |
saw base with the slots in the saw mounting brackets (D).
6. Feed a hex head bolt with flat washer installed through each of the four holes in the table saw base and mounting brackets. Secure each location with a flat washer, lock washer and nut provided.
WARNING: To reduce the risk of personal injury, be sure the table saw is fully anchored on the stand.
WARNING: The table saw must be positioned on the tool mount so that all four corners can be bolted to the mounting brackets. If the saw is mounted properly, the mounting brackets will be positioned perpendicular to the stand rail when the saw is placed on the stand.
English
4
