EN G L IS H
WARNING: ALWAYS wear working gloves while operating this tool.
WARNING: The gear case becomes very hot during use.
WARNING:
•Ensure all materials to be ground are secured in place.
•Apply only a gentle pressure to the tool. Do not exert side pressure on the disc.
•Avoid overloading. Should the tool become hot, let it run a few minutes under no load condition.
Proper Hand Position (fig. 1, 7)
WARNING: To reduce the risk of serious personal injury, ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal injury, ALWAYS hold securely in anticipation of a sudden reaction.
Proper hand position requires one hand on the side handle (d), with the other hand on the body of the tool, as shown in figure 7.
To avoid
MAINTENANCE
Your DEWALT power tool has been designed to operate over a long period of time with a minimum of maintenance. Continuous satisfactory operation depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of serious personal injury, turn tool off and disconnect tool from power source before making any adjustments or removing/installing attachments or accessories. Before reconnecting the tool, depress and release the trigger switch to ensure that the tool is off.
Pop-off Brushes
The motor will be automatically shut off indicating that the carbon brushes are nearly worn out and that the tool needs servicing. The carbon brushes are not
Switching On and Off (fig. 1)
WARNING: Before using the tool, check that the handle is tightened securely.
To run the tool first actuate the switch release button
(b) and then press the on/off switch (a).
For continuous operation hold the trigger switch (a) down.
To stop the tool, release the on/off switch.
WARNING: Do not switch the tool on or off when under load.
Metal Applications
When using the tool in metal applications, make sure that a residual current device (RCD) has been inserted to avoid residual risks caused by metal swarf.
If the power supply is shut off by the RCD, take the tool to authorised DEWALT repair agent.
WARNING: In extreme working conditions, conductive dust can accumulate inside the machine housing when working with metal. This can result in the protective insulation in the machine becoming degraded with a potential risk of an electrical shock.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of the main housing with dry air as often as dirt is seen collecting in and around the air vents. Wear approved eye protection and approved dust mask when performing this procedure.
WARNING: Never use solvents or other harsh chemicals for cleaning the
29
