EN G L I S H
Electrical Safety
The electric motor has been designed for one voltage only. Always check that the power supply corresponds to the voltage on the rating plate.
Machine is grounded (class I) in accordance with EN 60745, therefore earth connection is required.
If the supply cord is damaged, it must be replaced by a specially prepared cord available through the DEWALT service organization.
Mains Plug Replacement (U.K. & Ireland Only)
If a new mains plug needs to be fitted:
•Safely dispose of the old plug.
•Connect the brown lead to the live terminal in the plug.
•Connect the blue lead to the neutral terminal.
WARNING: Connect the yellow/green lead to the earth terminal.
Follow the fitting instructions supplied with good quality plugs. Recommended fuse: 13 A.
Using an Extension Cable
If an extension cable is required, use an approved
When using a cable reel, always unwind the cable completely.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of serious personal injury, turn tool off and disconnect tool from power source before making any adjustments or removing/installing attachments or accessories. Before reconnecting the tool, depress and release the trigger switch to ensure that the tool is off.
Attaching the Side Handle (fig. 4)
WARNING: Before using the tool, check that the handle is tightened securely.
Screw the front handle (c) tightly into the hole (l) Instructions for use.
Mounting an Grinding Disc (fig. 2)
1.Slacken the wing nuts (e) and swivel the bolts (f) to release the cover (g).
2.Open the cover.
3.Hold the spindle by inserting the Allen key into one of the holes in the inner flange.
4.Loosen the nut (h) using the spanner. Remove the nut and the outer flange (i).
5.Mount the accessory (j) on the spindle.
6.Replace the flange and securely tighten the nut.
7.Close the cover and lock it by tightening the wingnuts.
To remove the accessory, proceed in reverse order.
Mounting and Removing the Guard (fig. 3)
1.Remove the accessory as described above.
2.Loosen the bolts (k).
3.Slide the guard onto the tool as shown.
4.Securely tighten the bolts.
To remove the guard, proceed in reverse order.
Never operate the tool without the guard, except when polishing using a cloth disc.
Prior to Operation
•Install the guard and appropriate disc or wheel. Do not use excessively worn discs or wheels.
•Be sure the inner and outer flange are mounted correctly.
•Make sure the disc or wheel rotates in the direction of the arrows on the accessory and the tool.
OPERATION
Instructions for Use
WARNING: Always observe the safety instructions and applicable regulations.
WARNING: To reduce the risk of serious personal injury, turn tool off and disconnect tool from power source before making any adjustments or removing/installing attachments or accessories. Before reconnecting the tool, depress and release the trigger switch to ensure that the tool is off.
28
