English
•Wear safety goggles or other eye protection.Drilling operations cause chips to fly. Flying particles can cause permanent eye damage.
•Bits and tools get hot during operation. Wear gloves when touching them.
•Keep handles dry, clean, free from oil and grease. it is recommended to use rubber gloves. This will enable better control of the tool.
•An extension cord must have adequate wire size (AWG or American Wire Gauge) for safety. The smaller the gauge number of the wire, the greater the capacity of the cable, that is 16 gauge has more capacity than 18 gauge. An undersized cord will cause a drop in line voltage resulting in loss of power and overheating. When using more than one extension to make up the total length, be sure each individual extension contains at least the minimum wire size. The following table shows the correct size to use depending on cord length and nameplate ampere rating. If in doubt, use the next heavier gauge. The smaller the gauge number, the heavier the cord.
Voltage (Volts) | Total length of cord in meters (m) | ||||||
|
|
|
|
|
|
|
|
120 | - 127V | 0 - 7 |
| 7 - 15 | 15 - 30 |
| 30 - 50 |
|
|
|
|
|
|
| |
220 | - 240V | 0 - 15 |
| 15 - 30 | 30 - 60 | 60 - 100 | |
|
|
|
|
| |||
Rated Ampere | Minimal | ||||||
range |
| cord in meters (mm2 ) |
| ||||
0 | - 6A | 1.0 |
| 1.5 | 1.5 |
| 2.5 |
|
|
|
|
|
|
|
|
6 | - 10A | 1.0 |
| 1.5 | 2.5 |
| 4.0 |
|
|
|
|
|
|
|
|
10 | - 12A | 1.5 |
| 1.5 | 2.5 |
| 4.0 |
|
|
|
|
|
|
| |
12 | - 16A | 2.5 |
| 4.0 | Not Recommended | ||
|
|
|
|
|
|
|
|
WARNING: Always use eye protection.All users and bystanders must wear eye protection that conforms to ANSI Z87.1.
WARNING: Always wear proper personal hearing protection that conforms to ANSI S12.6 (S3.19) during use. Under some conditions and duration of use, noise from this product may contribute to hearing loss.
WARNING:ALWAYS use safety glasses.Everyday eyeglasses are NOT safety glasses. Also use face or dust mask if cutting operation is dusty. ALWAYS WEAR CERTIFIED SAFETY EQUIPMENT:
•ANSI Z87.1 eye protection (CAN/CSA Z94.3),
•ANSI S12.6 (S3.19) hearing protection,
•NIOSH/OSHA/MSHA respiratory protection.
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are:
•lead from
•crystalline silica from bricks and cement and other masonry products, and
•arsenic and chromium from
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles.
•Avoid prolonged contact with dust from power sanding, sawing, grinding, drilling, and other construction activities. Wear protective clothing and wash exposed areas with soap and water. Allowing dust to get into your mouth, eyes, or lay on the skin may promote absorption of harmful chemicals.
3
