Definitions: Safety Guidelines
The definitions below describe the level of severity for each signal word. Please read the manual and pay attention to these symbols.
DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury. 
WARNING: Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury. 
CAUTION: Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury.
NOTICE: Indicates a practice not related to personal injury which, if not avoided, may result in property damage.
IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR ANY DEWALT TOOL, CALL US TOLL FREE AT:
Miter Saw Stand with Folding Legs DWX723/DWX724
This stand is designed for use with most miter saws. If you have any problem with alignment or mounting, call
WARNING: For your own safety, read the miter saw 
instruction manual before using any accessory. Failure to heed these warnings may result in personal injury and serious damage to the miter saw and the accessory. When
servicing this tool, use only identical replacement parts.
Carton Contents
1Miter saw stand (DWX723 or DWX724)
2 Miter saw mounting brackets (DW7231)
2 Work piece support and length stops (DW7232)
1Hardware bag
Tools Required
•Drill with 3/8" (9.5 mm) drill bit (Not required for DEWALT Miter Saws)
•Crosshead #2 screwdriver
•1/2" (13 mm) Wrench
Components (Fig. 1)
WARNING: Never modify the stand or any part of it. Damage or personal injury could result.
Refer to Figure 1 for Components List.
General Safety Instructions for Miter Saw Stands
WARNING: To reduce the risk of personal injury:
•ALWAYS use eye protection. All users and bystanders must wear eye protection that conforms to ANSI Z87.1.
•ALWAYS check the stability of the miter saw stand and the miter saw attached to it before putting the stand or the saw into use.
•DO NOT mount any power tool other than a miter saw to this stand. Mounting other power tools to this stand could result in severe personal injury.
•DO NOT exceed the weight this stand can hold. The main center beam of the miter saw stand is designed to support 500 lbs. (227 kg.) safely in a work environment. It is unsafe to climb, sit or stand on the stand.
English
1
