![](/images/new-backgrounds/1121883/1218835x1.webp)
sensor located on the bottom of the mou- se will glow red.
Set the ID codes (Figure 2):
1.Press the link button on the receiver.
2.Press the link button on the bottom of the mouse. When you see the red light flash- ing that means the mouse and receiver are communicating successfully.
ON/OFF switch
Link button
Fig. 2
Link button
Mouse power management (Figure 2 & 3):
1.The mouse’s battery power capacity de- pends on the use of “ON/OFF” switch con- trol.
2.When power is “ON”, the mouse will go into “Sleep Mode” after 8 minutes if not used. You need to press a button or the scroll wheel to
3.To save the power, turn off the power while you are not using it or traveling.
Charging
indicator
Charging
cable
Fig. 3
Charging
ports
4.When the low battery indicator is flashing, it means the power is not enough. You should plug the charging cable on both
receiver & mouse for charging. The mou- se can be used while the batteries are charging. Make sure the mouse contains rechargeable batteries!
5.The charging indicator light is located at the end of the mouse. When you plug the charging cable in, the red LED will go on. When the battery is fully charged, the LED will turn to green. Please pay attention to the following notes while charging the mouse:
Note: Please charge at least 10 hours befo- re the first operation. Make sure PC or Note- book does not change to the stand by or sleep mode while charging.
The rechargeable batteries included are de- signed for a limited number of recharging cycles. The number of cycles depends on the device type as well as the recharging process itself. Incorrect charging of a battery can re- duce its lifetime and deviate from the lifecycle of the product. Therefore please charge the mouse only when the batteries have low power or are empty.
Federal Communications Commission Statement
Notice 1
You are cautioned that changes or modifica- tions not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment.
Notice 2
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reason- able protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio fre-