Dicota Phasor manual Mouse not detected, Screen Cursors does not move properly, Disclaimer

•Make sure the receiver is plugged in the USB port.

•Unplug the receiver and then plug in the receiver again. Make sure that it had been detected by the Operating Systems properly.

B. Mouse not detected

When using the mouse, it may not be detected by the Notebook/compu- ter or receiver. To remedy this problem, try the following:

•Make sure the receiver is plugged in the USB port.

•You may re-setup the connection RF Channel between the mouse and the receiver, especially, when you have been changed or recharged your batteries.

C. The Screen Cursors does not move properly

•Change the angle of your radio receiver. Try adjusting the receiver and/or mouse to improve reception.

•Make sure that the battery low indicator is NOT lit on. Replace batteries if the low battery indicator is lit on.

•You may also need to change the RF Channel for the mouse. Press the “Channel Reset” button on the receiver, then press the “Channel Reset” button on the mouse.

Disclaimer

Information in this document is subject to change without notice. The manufacturer does not make any representations or warranties (im- plied or otherwise) regarding the accuracy and completeness of this document and shall in no event be liable for any loss of profit or any commercial damage, including but not limited to special, incidental, consequential, or other damage. No part of this document may be reproduced or transmitted in any form by any means, electronic or mechanical, including photocopying, recording or information record- ing and retrieval systems without the express written permission of the manufacturer.

7