DigiTech RP80 Applying Power

Applying Power

There are two options for powering the RP80:battery power,and the included PS200R DC

power supply. Before applying power to anything,set your amp(s) to a clean tone and set the

tone controls to a flat EQ response (on most amps,this would be 0 or 5 on the tone controls).

The RP80 can be run for more than 15 hours on 6 AA batteries.The battery compartment

is located on the bottom of the RP80. The following diagram shows how to install the

batteries.

Note: Pay close attention to the battery polarity when installing batteries as

polarity changes direction for each pair.

Contents

Main Page DECLARATION OF CONFORMITY Warranty Page Page Page Page Rear Panel Making Connections Mono Operation Stereo Operation Applying Power Battery Power AC Power About the RP80 The Presets Tuner Page The Effect LEDs Storing/Copying a Preset Effect Definitions Preset Level Pickup/Wah Compressor Amp/Cabinet Modeling EQ Noise Gate Chorus/Mod Page Page Detune (d1-d9) Pitch Shift (H1-H9) 19 Whammy (h1-h9) Delay Reverb Other Functions Expression Pedal Page Drum Machine Global Cabinet Modeling Factory Reset Expression Pedal Calibration Appendix Specifications: Preset List (User/Factory)