![](/images/new-backgrounds/1028999/2899917x1.webp)
Fireplace Installation
is not susceptible to moisture and is away from drapes, furniture and high traffic.
2.Place the fireplace in the desired location to see how it will look in the room.
3.Mark the desired location on the floor and store the fireplace in a safe, dry and dust free location.
4.Use studs to frame an opening of 31 ¾ inches (807
mm)wide x 22 ¾ inches (578
mm)high x 9 ½ inches (241
mm)deep.
Option #1 - The power cord can be lead from behind the trim and along the wall to an outlet near the fireplace.
Option #2 - A new outlet can be installed inside the new frame construction. Plug the unit into a 15 Amp, 120 Volt outlet. If the cord does not reach, you may use an extension cord rated for a minimum of 1875 Watts.
Option #3 - Hardwire
1.Wire a dedicated, properly fused circuit with 120 Volt, 15 Amp rating. Allow up to eight
(8) feet (2.4 m) of service cable for connecting power supply to junction box on
fireplace when installing after finishing wall.
CAUTION: Use two conductor,
(3)wires total) for the incoming power supply on fireplace inserts.
Use appropriate wire to meet local and national electrical codes for rated power consumption.
2.Remove the outer jacket and strip the individual conductor from the end.
3.Loosen the screw securing the junction box cover and remove the cover.
4.Take the cables out from the junction box, loosen the two wire twist nuts and remove the power cord (Figure 2).
5.Route the power supply wire through the knockout on supplied alternative junction
Figure 2
9