Maintenance
Light Bulb Replacement
Allow at least five (5) minutes for light bulbs to cool before touching bulbs to avoid accidental burning of skin.
Light bulbs need to be replaced when you notice a dark section of the flame or when the clarity and detail of the log ember bed exterior disappears. There are three (3) bulbs under the log set, which generate the flames and embers, and two (2) bulbs above the log that illuminate the log exterior.
Lower Light Bulb Requirements
Quantity of three (3) clear chandelier or candelabra bulbs with an
Do not exceed 60 Watts per bulb.
Helpful Hints: It is a good idea to replace all light bulbs at one time if they are close to the end of their rated life. Group replacement will reduce the number of times you need to open the unit to replace light bulbs. Care must be taken when removing the log set as the log set contains LED’s and wires.
Figure 8
Upper Bulbs
Log Set
| Lower |
| LED Bulbs |
Front | Wire Harness |
| |
Glass |
|
To access the lower light bulb area:
1.Remove front glass assembly.
2.Pull the front edge of the plastic ember bed or plastic grate up and forward until the rear tab releases from the ledge located at the bottom of the Partially Reflective Glass
(Figure 10).
!IMPORTANT: Only handle the log set by the ember bed.
!NOTE: Log set fits tightly
into firebox, some force may be necessary to remove.
3.Set log set in front of fireplace.
4.Disconnect the log set LED wire harness from unit.
5.Gently pull the flicker rod to the right as far as possible
16 | www.dimplex.com |
