DFO2307
If unit was operating prior to servicing allow at least 10 minutes for light bulbs and heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of electric shock or damage to persons.
FLAME ROD AND MOTOR REPLACEMENT
1.Remove the front glass as shown on page 6 of this manual.
2.Remove the top trim piece by removing the 3 retaining screws.
3.Remove the 10 retaining screws and lift the top off of the unit
1.Remove the reflector rod from the flame motor by pulling the end of the rod to the left and carefully remove flame rod from rubber sleeve.
4.Remove the 2 screws securing the flame motor to the flame motor bracket
5.Disconnect motor wiring connections form circuit board.
6.Discard the old motor.
7.Reassemble in the reverse order as above.
10
