Operation
step. Failure to do so will result in these steps needing to be followed again.
This will synchronize the remote control transmitter and receiver.
Battery Replacement
①Slide battery cover open on the hand held transmitter
(Figure 4).
②Correctly install one (1) 12 Volt
(A23) battery in the battery holder.
③Close the battery cover.
Maintenance
WARNING: Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire, electric shock or damage to persons.
Light Bulb Replacement
CAUTION: Allow at least five
(5)minutes for light bulbs to cool off before touching bulbs to avoid accidental burning of skin.
Light bulbs need to be replaced when you notice a dark section of the flame or when the clarity and detail of the log exterior disappears. There are two bulbs under the log set which generate the flames and embers.
Tool Requirements: Phillips screw driver
Helpful Hints
It is a good idea to replace all light bulbs at one time if they are close to the end of their rated life. Group replacement will reduce the number of times you need to open the unit to replace light bulbs.
Upper Light Bulb Requirements
Quantity of one (1) clear chandelier or candelabra bulbs with an
Upper Bulb Replacement
1.Open door by pulling the
10 | www.dimplex.com |
