Installation continued
5.Insert top screw into the wall, allowing it to protrude by approximately 3mm.
6.Hook wall box on to screw using keyhole slot provided.
7.Mark position of remaining fixings, remove box and complete fixing.
8.Fix the wall box to the wall, ensuring the drain hole is at the bottom.
9.Cable entries are made to the base of the box, using the holes provided.
10.Connect circuit wiring to terminal block. (see Fig.2.)
N = Neutral to load
N = Supply Neutral
N | N | SLI | L | = Earth terminal |
|
|
|
| |
|
|
|
| SLI = Supply to load |
|
|
|
| L = Supply live |
11. Plug detector head into the back box socket.
Secure detector to wall box with screws provided and cover screws with screw caps.
Adjusting PIR Range
Limit the range and angle of detection as appropriate by adjusting the detector head and by using the lens masking plates provided. Cut the appropriate segments from the lens mask to cover the area of the lens that requires masking.
|
| A1 |
| A2 |
| A3 |
| A4 |
| Long Range |
|
| B1 |
| B2 |
| B3 |
| B4 |
| Inner Range |
|
| C1 |
| C2 |
| C3 |
| C4 |
| Short Range |
90º | 45º |
| 0 | 45º | 90º | |||||
15m | 12m | 3m | 3m | 12m | 15m |
|
| C1 | C4 |
| 90º |
| B1 |
|
| ||
A1 | C2 | C3 | B4 |
| |
|
|
|
| A4 | |
|
| B2 | B3 |
| |
|
|
|
| ||
45º |
| A2 | A3 |
| 45º |
|
|
| |||
|
|
|
|
| |
|
|
| 0 |
|
|
15m | 15m |
| 90º |
45º
Masked Areas
AC | A4 |
B3 | B4 |
C3 | C4 |
Masked Areas
A1 | A2 | A4 |
B1 | B2 | B4 |
C1 | C2 | C4 |
