OPERATION
FIGURE 1
FIGURE 2
REMOTE CONTROL
The Optiflame fireplace is supplied with a radio frequency remote control (all models except BF36E). This remote control has a range of approximately 50ft. (15.25m), it does not have to be pointed at the fireplace and can pass through most obstacles (including walls). It is supplied with one of 243 independent frequencies to prevent interference with other units. The frequency designation is indicated on the back of the transmitter (FIGURE 1).
A. Remote Control Initialization
This procedure is required every time there is a loss of power to the remote control in the fireplace (i.e. power failure, breaker tripped, main power switch is turned off)
1.Ensure that power is supplied through main service panel.
2.Access the manual controls, (remove glass doors if applicable) pull right hand edge of right hand steel curtain towards the center of unit. (FIGURE 2)
3.Locate manual controls refer to FIGURE 3.
4.Activate main power switch, red indicator light 1 will flash.
5.Press ON button located on the remote control transmitter (FIGURE 1). This will synchronize the remote control transmitter and receiver.
B. Remote Control Usage
The remote control operates the fireplace levels sequentially. The level is increased every time the ON button on the transmitter is pressed. The fireplace can be turned off at any point by pressing the OFF button on the remote control transmitter.
2
