REMOTE CONTROL USUAGE
The corner wall mounted electric fireplace is supplied with a radio frequency remote control. This remote control has a range of approximately 50 feet (15.25m), it does not have to be pointed at the fireplace and can pass through most obstacles (including walls). It is supplied with one of 243 independent frequencies to prevent interference with other units. The frequency designation is indicated on the back of the transmitter.
FIGURE 14
Manual
Selection
Switch
Main
Power
Switch
Level 3 Indicator
A. Remote Control Initialization
This procedure is required every time there is a loss of power to the remote control in the fireplace.
(i.e. power failure, breaker tripped, main power switch is turned off)
1.Ensure that power is supplied through main service panel.
2.Locate manual controls. (refer to FIGURE 13)
3.Activate main power switch, red indicator light 1 will flash.
4.Press and hold the heater control switch for five seconds. The second red indictor light will flash.
5.Press ON button located on the remote control transmitter (FIGURE 14). This will synchronize the remote control transmitter and receiver.
B. Remote Control Usage
The remote control operates the fireplace levels sequentially. The level is increased every time the ON button on the transmitter is pressed. The fireplace can be turned off at any point by pressing the OFF button on the remote control transmitter.
Level 1: The flame effect is turned on and the first red indicator light is activated.
Level 2: The flame effect remains on, the heater is activated to the low heat setting, and the first and second red indicator lights are activated.
Level 3: The flame effect remains on, the heater is set to the high heat setting, and all three red indicator lights are activated.
FIGURE 15
Level 2 Indicator
Level 1 Indicator
9
