Dimplex EWMC-CC-SS manual Tools

Models: EWMC-CC-SS

1 9
Download 9 pages 22.59 Kb
Page 6
Image 6
TOOLS

NOTE

A 15amp, 120 volt circuit is required. A dedicated circuit is preferred but not essential in all cases. A dedicated circuit will be required if, after installation, the circuit breaker trips or the fuse blows on a regular basis when the heater is operating. Additional appliances on the same circuit may exceed the current rating of the circuit breaker.

WARNING

Placing heavy objects on top of this fireplace may cause damage or injury. Maximum suggested weight to be placed on top of unit is 25 lbs/11 kg. Do not use fireplace as a seat or step.

WARNING

Ensure the power cord is not installed so that it is pinched or against a sharp edge and ensure that the power cord is stored or secured to avoid tripping or snagging to reduce the risk of fire, electric shock or injury to persons.

Construction and electrical outlet wiring must comply with local building codes and other applicable regulations to reduce the risk of fire, electric shock and injury to persons.

Do not attempt to wire your own new outlets or circuits. To reduce the risk of fire, electric shock or injury to persons, always use a licensed electrician.

WARNING

The supplied mounting brackets are designed for use with Dimplex corner wall mounted fireplaces only. Improper use, or use for purposes other than intended, may cause damage or injury.

CORNER WALL MOUNTED ELECTRIC FIREPLACE INSTALLATION

WARNING

Failure to install the corner wall mounted electric fireplace as instructed below may result in damage to the equipment and or may expose the user to the risk of fire, serious injury, illness or death.

WARNING

The corner wall mounted electric fireplace requires each wall mounting bracket to be installed into a minimum of one wall stud.

TOOLS

Drill, ½” drill bit, slotted screwdriver, angle divider, stud locator.

NOTE

For optimum installation the corner wall mounted electric fireplace should be installed in a 90° corner ± 3°. The use of washers (included) may be required if the corner is not within the specified tolerance.

1. Select the desired corner near an electrical outlet. (power cord length is 5 feet)

2. Ensure the front of the unit when installed is at least 3 feet (0.9m) from combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains.

3.Mount the unit in the corner with the bottom trim being at a minimum of 15”

(mounting bracket 50”) above the floor.

 

 

(FIGURE 1 & 2)

 

 

NOTE

FIGURE 1

FIGURE 2

It is recommended that the bottom trim of the

unit not be mounted higher than 18” from the

 

 

ground (mounting bracket no higher than 53”).

 

 

(FIGURE 1 & 2)

 

3

Page 6
Image 6
Dimplex EWMC-CC-SS manual Tools

FAQ

What is the required circuit for Dimplex EWMC-CC-SS?

A 15amp, 120 volt circuit is required. A dedicated circuit is preferred but not essential in all cases.

What is the maximum weight suggested to be placed on top of the unit?

The maximum suggested weight to be placed on top of the unit is 25 lbs/11 kg.

What tools are required for installation?

Drill, drill bit, slotted screwdriver, angle divider, and stud locator.