Wall Mounting
IMPORTANT – The wall brackets supplied with the appliance must be used. The heater should be positioned observing the minimum clearances stated around the heater - see Fig. 1.
DO NOT locate the heater immediately below a fixed socket outlet or connection box.
1.Remove wall mounting bracket from the back of the heater by depressing the spring latch at the top of each bracket - see Fig. 2.
2.Fix the wall bracket securely to the wall through the four screw holes provided.
3.Present the heater to the wall bracket, and engage lower slots in the back with bracket.
4.Raise the heater to upright position and push the heater onto brackets to engage top latch.
255 MIN
Fig. 2
Access to the controls
The controls cover (see ‘x’ in Fig. 1) on your heater has a latch which may be locked shut if desired using a small bladed screwdriver - see Fig. 3.
To open the cover insert the blade of the screwdriver in the small slot and rotate a quarter of a turn clockwise to disengage the latch. The cover may then be hinged back towards the wall for access to the controls.
Fig. 3
Operation - Thermostat only models
Control of Output and Temperature (see Fig. 4)
The switch marked O and I controls the electricity supply to the heating elements. The OFF position is marked O.
The switch marked I - II (half heat – full heat) provides a choice of output as desired.
Thermostat Operation
The heater is fitted with an adjustable thermostat enabling the room temperature to be controlled by adjusting the setting
accordingly. The * setting represents a room temperature of approximately 5°C and may be used for protection against frost. Higher temperature settings range from
A neon indicator light glows when the appliance is actually heating.
Switch on the heater and turn the thermostat knob to mark 6 opposite the indicator mark (located on centre right of the knob - see Fig. 4 & 5), and set selector switch to full heat output to warm the room rapidly. When the room temperature has reached the desired level, turn the thermostat knob back slowly until the thermostat just clicks off. The heater will then maintain the room temperature at the chosen level, provided that the correct size of heater has been selected for the room to be heated.
NOTE – Should your heater fail to come on when the thermostat knob is at a low setting, this may be due to the room temperature being higher than the thermostat setting.
Operation - TI and TX Timer Models
Control of Output and Temperature (see Fig. 5)
The slide switch on the timer unit controls the electricity supply to the heating elements on TI and TX models.
The switch marked I - II (half heat – full heat) provides a choice of output as desired.
Fig. 5
Thermostat Operation
- see above.
Using the Timer
The heater must be connected to the electricity supply for the timer to operate. Set the timer by rotating the dial clockwise until the correct time of day is indicated opposite the datum mark (located at centre front of the timer - see Fig. 5).
‘OFF’ Position
Set the timer switch to 
position. The timer operates but the heater will not output any heat, as the electricity supply to the heating elements has been disconnected.
Manual Operation
Set the timer switch to 
position. The heater will now operate continuously under the control of the thermostat - see ‘Thermostat Operation’ above.
Fig. 4
