Dixon 13086-0601 manual Specifications, Model ZTR

	SPECIFICATIONS
	Model ZTR 3303
CHASSIS:	Twin 12 gauge side frames and 7 gauge
	transmission and engine base plate.
BODY:	All body parts made of rotational molded polyethylene.
	Front body contains access panel for battery service.
	Seat tilts forward to allow transmission service.
MOWER DECK:	11 GA stamped steel construction. Single 30” cut blade.
	Cut height approximately 1”-4” via 7-position lift handle
BLADE DRIVE:	Mechanical; hand lever engagement
TRANSMISSION:	Each rear wheel is independently driven by chain and
	sprockets through a friction mechanical drive.
ENGINE:	10.5 HP I/C Briggs & Stratton, 4-Cycle, Single Cylinder,
	Air-Cooled, Gasoline, Vertical Shaft, Aluminum Head
	and Block.
STARTING SYSTEM:	Electric by key switch operation with safety interlocks
	on parking brake and blade drive.
TIRES:	Front	11 x 4.00-5 ribbed tread.
	Rear	16 x 6.50-8 Turf Trac R/S tread
RECOMMENDED	Front	16-21 PSI
TIRE PRESSURE:	Rear	8-14 PSI
CAPACITIES:	Fuel	2.0 gallons total
	Engine	1.25 quarts oil
DIMENSIONS:	Width	32.5” outside rear wheel measurement
	Height	32.0” to top edge of seat
	Length	65.5” hitch tab to front bumper
	Weight	430 lbs.

Additional information provided in service instructions under the individual component.

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE

13