CONTROLS
BLADE DRIVE: Models ZTR 3303 & 3304
•Located to left of the operator.
•To engage the mower blade, turn lever on floor slowly to the “ON” position.
•To disengage mower blade, turn lever to the “OFF” position.
BLADE DRIVE: | Model ZTR 3014 |
•Located on the control panel, operator’s right.
•To engage mower blades, pull up on the switch.
•To disengage blades, push down.
CIRCUIT BREAKER:
•Protection of the electrical system is by (1) 15 amp circuit breaker.
•If circuit breaker trips, push button to reset.
•If this condition repeats, consult dealer for inspection and repair.
THROTTLE CONTROL LEVER:
•Located on control panel to operator’s right.
•Throttle control for engine speed.
•Choke for engine starting.
•Throttle control should be set to MAXIMUM or wide open setting to ensure adequate cooling of the engine and to maintain mower deck blade speed while mowing.
MOWER DECK CUT HEIGHT LIFT LEVER:
•Located to the left of the operator.
•Controls the cutting height.
•Seven positions of adjustment.
•Move lever in and forward to lower.
•Move lever in and back to raise.
NOTE: Always use high for transport.
19
