Electrical Systems, Cleaning The Mower, Warranty | Dixon 14295-0804

CARE AND MAINTENANCE

ELECTRICAL SYSTEMS:

Keep all connections clean and tight.

CLEANING THE MOWER:

Wash mower periodically. Clean above and below deck.

High pressure washing and alkaline based soaps can cause damage to bearings and other parts of the mower. After washing your mower, start the engine and engage the mower deck for a few minutes to disperse any water that may have accumulated in bearings, pulleys or fans.

Note:	Allow mower to cool before washing. If
	bearings are hot, they will draw moisture
	inside as they dry and cause corrosion.

SERIAL NUMBERS:

The serial number is located on frame at rear of engine.

WARRANTY:

Refer to warranty information (pages 16).

PARTS/SERVICE:

See your Dixon® dealer for replacement parts, warranty or service.

37

Image 37

Dixon 14295-0804 Electrical Systems, Cleaning The Mower, Serial Numbers, Warranty, Parts/Service, Care And Maintenance

Contents

ZEETER Safety Instructions & Operator’s Manual IMPORTANT - READ CAREFULLY SAFETY & WARNING TABLE OF CONTENTSCARE & MAINTENANCE TROUBLESHOOTING Blade Contact Tip Over Run Over Back Over SAFETY When you see this symbol, BE ALERT to the potential for injury Safety Alert SymbolFollow the recommended safety precautions and safe operating practices GENERAL OPERATION GENERAL OPERATION continued Maintain or replace safety & instruction labels as needed SLOPE OPERATION SLOPE OPERATION continued Do not mow on wet grass. Reduced traction could cause sliding FIRE HAZARDS FIRE HAZARDS continued CHILDREN SERVICE DIXON ZTR RESIDENTIAL WARRANTY POLICY ZEETER - Residential Mower SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE SPECIFICATIONS CONTROL LEVERS CONTROLS TO SET PARKING BRAKE PARKING BRAKE 7. Know how to stop engine. Turn key to off position 1. Read engine manufacturer’s operating and maintenance instructionsBEFORE OPERATING MOWER 3. Check engine oil 4. Check fuel cap to be sure it is in place TOWING TRAILERS AND OTHER ATTACHMENTS TRANSMISSION DRIVE SYSTEM THROTTLE CONTROL LEVER BLADE DRIVEMOWER DECK CUT HEIGHT LIFT LEVER OPERATION INSTRUCTIONS STARTING INSTRUCTIONS TESTING OF SAFETY INTERLOCK SYSTEMS MOWING WITH A MULCHING ATTACHMENT MOWING WITH A MULCHING ATTACHMENT continued MOWING WITH A GRASS CATCHER ATTACHMENT Failure to observe the following instructions MOWING WITH A GRASS CATCHER ATTACHMENT continuedWARNING may result in personal injury 5. Maintain sharp blades throughout the cutting season SIDE DISCHARGE OF THE CLIPPINGS GRASS HEIGHT & CUTTING SUGGESTIONS MAINTENANCE SCHEDULE CARE AND MAINTENANCEBefore performing any maintenance, turn off engine allow to cool & remove key Use extreme care when working on machinery CUTTER BLADE MAINTENANCE ENGINE BATTERY LUBRICATION BELTS TIRESBELT TENSION Engine to Transmission Belt - P/N WARRANTY CLEANING THE MOWERPARTS/SERVICE ELECTRICAL SYSTEMS CHANGING THE ENGINE OIL OIL FILL MOWER DECK LEVELING PROCEDURE Illustration A IllustrationB Maintenance REAR CHAIN ADJUSTMENTDO NOT OVERTIGHTEN CHAIN DECK REMOVAL DRIVE SYSTEM ADJUSTMENTS BLADES STANDARD SERVICE PARTS LISTENGINE AIR AND OIL FILTERS 1. ENGINE WON’T TURN OVER TROUBLESHOOTING2. ENGINE WILL TURN OVER BUT WON’T START 3. HARD TO START ENGINE 8. ENGINE STALLS WHEN BLADES ARE ENGAGED 7. MOWER LOSES POWER OR TRANSMISSION OVERHEATS6. ENGINE RUNS BUT MOWER WON’T MOVE FORWARD 9. DRIVE SYSTEMPage Page Page Name Address OWNER’S INFORMATIONDATE OIL CHANGED DATE ENGINE TUNED ZEETER Dixon and ZTR are registered trademarks of Dixon Industries, Inccancer, birth defects or other reproductive harm