Rear Chain Adjustment, Maintenance | Dixon 14295-0804 specification

CARE AND MAINTENANCE

REAR CHAIN ADJUSTMENT:

CAUTION

Stop engine, remove key and set parking brake before attempting to adjust the rear chain.

Proper tension for the rear chains is accomplished through the use of an adjuster located at mid-point of each rear chain.

To adjust, tighten the nut on top of the rubber spring until the chain has approximately 1/4” movement up and down when measured at mid-point. Refer to Illustration B, page 41.

NOTE:	Adjust rear drive chains after first 10 hours of
	use and every 40 hours thereafter.
NOTE:	DO NOT OVERTIGHTEN CHAIN!

Maintenance:

Periodically remove any build-up of grass, mud or other debris from both the spring loaded roller and the upper guide rod. The use of a high quality chain lubri- cant is recommended.

42

Image 42

Dixon 14295-0804 manual Rear Chain Adjustment, Care And Maintenance, Do Not Overtighten Chain

Contents

Safety Instructions & Operator’s Manual ZEETER IMPORTANT - READ CAREFULLY CARE & MAINTENANCE TABLE OF CONTENTSSAFETY & WARNING TROUBLESHOOTING SAFETY Blade Contact Tip Over Run Over Back Over Follow the recommended safety precautions and Safety Alert SymbolWhen you see this symbol, BE ALERT to the potential for injury safe operating practices GENERAL OPERATION GENERAL OPERATION continued Maintain or replace safety & instruction labels as needed SLOPE OPERATION SLOPE OPERATION continued Do not mow on wet grass. Reduced traction could cause sliding FIRE HAZARDS FIRE HAZARDS continued CHILDREN SERVICE ZEETER - Residential Mower DIXON ZTR RESIDENTIAL WARRANTY POLICY SPECIFICATIONS SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE CONTROLS CONTROL LEVERS PARKING BRAKE TO SET PARKING BRAKE BEFORE OPERATING MOWER 1. Read engine manufacturer’s operating and maintenance instructions7. Know how to stop engine. Turn key to off position 3. Check engine oil 4. Check fuel cap to be sure it is in place TRANSMISSION DRIVE SYSTEM TOWING TRAILERS AND OTHER ATTACHMENTS BLADE DRIVE THROTTLE CONTROL LEVERMOWER DECK CUT HEIGHT LIFT LEVER OPERATION INSTRUCTIONS STARTING INSTRUCTIONS TESTING OF SAFETY INTERLOCK SYSTEMS MOWING WITH A MULCHING ATTACHMENT MOWING WITH A MULCHING ATTACHMENT continued MOWING WITH A GRASS CATCHER ATTACHMENT MOWING WITH A GRASS CATCHER ATTACHMENT continued Failure to observe the following instructionsWARNING may result in personal injury SIDE DISCHARGE OF THE CLIPPINGS 5. Maintain sharp blades throughout the cutting season GRASS HEIGHT & CUTTING SUGGESTIONS Before performing any maintenance, turn off engine CARE AND MAINTENANCEMAINTENANCE SCHEDULE allow to cool & remove key Use extreme care when working on machinery CUTTER BLADE MAINTENANCE BATTERY ENGINE LUBRICATION BELT TENSION TIRESBELTS Engine to Transmission Belt - P/N PARTS/SERVICE CLEANING THE MOWERWARRANTY ELECTRICAL SYSTEMS CHANGING THE ENGINE OIL OIL FILL MOWER DECK LEVELING PROCEDURE Illustration A IllustrationB REAR CHAIN ADJUSTMENT MaintenanceDO NOT OVERTIGHTEN CHAIN DECK REMOVAL DRIVE SYSTEM ADJUSTMENTS STANDARD SERVICE PARTS LIST BLADESENGINE AIR AND OIL FILTERS 2. ENGINE WILL TURN OVER BUT WON’T START TROUBLESHOOTING1. ENGINE WON’T TURN OVER 3. HARD TO START ENGINE 6. ENGINE RUNS BUT MOWER WON’T MOVE FORWARD 7. MOWER LOSES POWER OR TRANSMISSION OVERHEATS8. ENGINE STALLS WHEN BLADES ARE ENGAGED 9. DRIVE SYSTEMPage Page Page DATE OIL CHANGED OWNER’S INFORMATIONName Address DATE ENGINE TUNED Dixon and ZTR are registered trademarks of Dixon Industries, Inc ZEETERcancer, birth defects or other reproductive harm