Dixon 3000 Series manual Specifications, Model ZTR3304

SPECIFICATIONS

Model ZTR3304

CHASSIS:

BODY:

MOWER DECK:

BLADE DRIVE: TRANSMISSION:

ENGINE:

STARTING SYSTEM:

TIRES:

CAPACITIES:

DIMENSIONS:

The monocoque design chassis of the 3000 Series Models incorporates CNC Laser and CNC brake processes to form the twin 12 gauge side frames and 7 gauge transmission and engine base plate.

All body parts are made of rotational molded polyethylene. Front body contains access panel for battery service. Seat tilts forward to allow transmission service.

1 1 GA stamped steel construction. Single 30" cut blade. Cut height approximately 1 " to 4" via 7 position lift handle.

Mechanical; hand lever engagement.

Each rear wheel is independently driven by chain and sprockets through a friction mechanical drive.

14 HP Briggs & Stratton I/C, Quiet, 4-Cycle, Single Cylinder, Air-Cooled, Gasoline, Vertical Shaft, Cast Iron Cylinder, Synchro-Balanced, Laminated Shroud

Electric by key switch operation with safety interlocks on parking brake and blade drive.

Front	11 X 4.00-5 ribbed tread. Rear
1 6 X 6.50 X 8 Turf Trac R/S Tread.
Fuel	2.0 gallons total.
Engine	1 .25 quarts oil.
Width	32.5" outside rear wheel measurement.
Height	32.0" to top edge of seat. Length
65.5" hitch tab to front bumper. Weight		440 Ibs.

NOTE:	Additional information provided in service instructions under the individual component.
	SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.

Page 9