Dixon 3000 Series manual Model ZTR, Specifications, Page

SPECIFICATIONS

Model ZTR 3014

CHASSIS:

BODY:

MOWER DECKS:

BLADE DRIVE: TRANSMISSION:

ENGINE:

STARTING SYSTEM:

TIRES:

CAPACITIES:

DIMENSIONS:

The monocoque design chassis of the 3000 Series Models incorporates CMC Laser and CMC brake processes to form the twin 1 2 gauge side frames and 7 gauge transmission and engine base plate.

All body parts are made of rotational molded polyethylene. Front body contains access panel for battery service. Seat tilts forward to allow transmission service.

36" Deck: 1 1 GA Laser Cut Fabricated - 36" Cut Width 42"

Deck: 1 3 GA Stamped Steel Construction - 42" Cut Width Cut height approximately 1" to 4" via 7 position lift handle.

Electric clutch.

Each rear wheel is independently driven by chain and sprockets through a friction mechanical drive.

14 HP Briggs & Stratton OHV I/C Quiet, 4-Cycle, Single Cylinder, Air-Cooled, Gasoline, Vertical Shaft, Cast Iron Cylinder, Synchro-Balanced, Laminated Shroud.

Electric by key switch operation with safety interlocks on parking brake and blade drive.

Front	11	X 4.00 -5 ribbed tread. Rear
1 8 X 8.50 X 8		Multi Trac tread.
Fuel	2.0 gallons total.
Engine	1 .25 quarts oil.
Width	43.0" outside rear wheel measurement. Height
36.0" to top edge of seat. Length				65.5" hitch tab to front
bumper. Weight			36" Deck: 500 Ibs.		42" Deck:
520 Ibs.

NOTE:	Additional information provided in service instructions under the individual component.
	SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.

Page 10