Dixon 6000 Series manual Specifications, Series Forward Mount

	SPECIFICATIONS
	6000 Series Forward Mount
CHASSIS:	Sheet metal construction frame
BODY:	Folded sheet metal. Seat lifts up for access to battery and belt service.
SEAT:	Designed for operator comfort by use of high density closed cell foam
	padded back and arm rests, upholstered with CorduraTM water-repellent
	fabric. Seat is adjustable fore and aft.
MOWER DECK:	2 Decks are available. 60" & 48" are made of 12 GA fabricated welded
	construction with 10 GA reinforcement plate. 3 blades combine for either
	a 48" or 60" cut width. Cut height approximately 1" to 5" via 9 position
	lift handle.
BLADE DRIVE:	Electric clutch
DRIVE SYSTEM:	Each rear wheel is independently driven by a HydroGear BDU-10L
	Series 70 hydrostatic transmission. The hydrostatic transmissions, in
	turn, power a fully enclosed HydroGear gearbox.
ENGINE:	22HP Kohler Command, 4-Cycle, V-Configuration, Overhead Valve,
	Air-Cooled, Gasoline, Horizontal Shaft, Aluminum Head, and Crankcase
	with Cast Iron Liners, Full Pressure Lubrication/Full Flow Filter, Pulse-
	type Fuel Pump, Fixed Jet Carburetor w/Smart-Choke, Electronic Ignition,
	In-Line Fuel Filter, Dual Element Air Cleaner.
STARTING SYSTEM:	Electric by key switch operation with safety interlocks on parking brake
	and blade drive clutch.
TIRES:	Front	4.10x3.50x4
	Rear	5.00-6x13
	Drive	20-10.0x10
RECOMMENDED	Front	16 lbs.
TIRE PRESSURE:	Rear	12 lbs.
CAPACITIES:	Fuel - 5 gallons
	Hydrostat oil tank - 3 quart with in-line 40 micron filter
	Hydrostat oil recommendation, refer to page 25
	Engine - 2 qts. SAE 10W30 (with filter)
DIMENSIONS:	Width	57-1/2”(48" Deck), 69-1/2"(60" Deck)
	Height	45-1/2"
	Length	96" (48” Deck), 101” (60” Deck)
	Weight	960 lbs. (48" Deck), 1030 lbs. (60" Deck)
NOTE:	Additional information provided in service instructions under the individual
	component.

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE

Page 11