Dixon 6025 manual Specifications, Model ZTR, Chassis

SPECIFICATIONS

Model ZTR 3014

CHASSIS:	Twin 12 gauge side frames and 7 gauge transmission and engine base plate.
BODY:	All body parts are made of rotational molded polyethylene. Front body contains
	access panel for battery service. Seat tilts forward to allow transmission service.
MOWER DECKS:	36" Deck:	11 GA Laser Cut Fabricated	- 36" Cut Width
	42" Deck: 13 GA Stamped Steel Construction - 42" Cut Width
	Cut height approximately 1" to 4" via 7 position lift handle.
BLADE DRIVE:	Electric clutch.
TRANSMISSION:	Each rear wheel is independently driven by chain and sprockets through a
	friction mechanical drive.
ENGINE:	14.5 HP Briggs & Stratton OHV I/C Quiet, 4-Cycle, Single Cylinder, Air-
	Cooled, Gasoline, Vertical Shaft, Cast Iron Cylinder, Synchro-Balanced,
	Laminated Shroud.
STARTING SYSTEM:	Electric by key switch operation with safety interlocks on parking brake and
	blade drive.
TIRES:	Front	11 X 4.00 -5 ribbed tread.
	Rear	18 X 8.50 X 8 Multi Trac tread.
RECOMMENDED	Front	16-21 PSI
TIRE PRESSURE:	Rear	8-10 PSI
CAPACITIES:	Fuel	2.0 gallons total.
	Engine	1.25 quarts oil.
DIMENSIONS:	Width	43.0" outside rear wheel measurement.
	Height	36.0" to top edge of seat.
	Length	65.5" hitch tab to front bumper.
	Weight	36" Deck: 500 lbs.	42" Deck: 520 lbs.
NOTE:	Additional information provided in service instructions under the individual
	component.

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.

Page 13