ASSEMBLY
3CONTAINER MOUNTING
1.Remove plastic end caps from the center two bag support arms. Fully insert spacer plugs into the ends of the support tubes. It may be necessary to tap the spacers into place with a hammer or mallet. Replace the plastic end cap back over the spacer. The additional extension will hold the hood more securely when latched.
5CONTAINER MOUNTING
1.Install containers on supports, overlapping at center supports.
2.Close cover and lock latch handles over center support tubes.
Center
Support
Tubes
Insert spacers
Remove centerand replace caps end caps
4 MOUNTING COVER ASSEMBLY
NOTE: Assistance from another person may ease mounting the cover assembly to mower.
1.Lift and rotate cover to align the cover brackets with support assembly tubes.
2.Slide the cover down over the support tubes until secure.
WARNING!
DO NOT operate mower unless container is properly installed. Container is subject to wear and deterioration, check containers frequently, replace when cracked or damaged. Use only a recommended replacement container.
9
