English-23
CONTROLS
13. Cutting height pedal
The cutting deck height is obtained by
pressing the foot pedal lift arm forward and
releasing the transport latch. Then lower the
deck to the preset height. To raise the deck
push forward on the foot pedal lift arm until
the transport latch locks. The cutting height
range is from 1 1/2" (38 mm) to 4 1/2"
(114 mm) in 1/4" (6.4 mm) increments. The
heights are measured from the ground up to
the blade tip with the engine not running.
To change cutting heights move the pin on
the cutting height plates to the desired height
of cut.
Accessories
For mulching, there is a BioClip attachment
available. This is mounted underneath the
mower deck and consists of control plates
and BioClip blades.
1. Foot pedal
2. Lift arm
3. Height plate
Cutting height pedal
1
2
3
8050-152
IMPORTANT INFORMATION
In order to obtain an even cutting height it
is important that the air pressure in all
four tires is the same 15 psi (1 bar).