14
CONTROLS
MOWER BLADE SWITCH:
To engage blades: pull up on switch.
To disengage blades: push down.
IGNITION SWITCH
:
Turn to run position to energize glow
plugs. Turn to start position when glow
plug light turns off, then crank engine.
Release when it starts.
For headlights - rotate switch one
notch counter-clockwise from run.
NOTE: Remove key when mower is
not in use.
THROTTLE CONTROL LEVER:
Located on control panel to operator's right. Controls engine speed.
While mowing, throttle control should be set to MAXIMUM or wide open setting to
insure adequate cooling of the engine and to maintain mower deck blade speed.
CIRCUIT BREAKER:
If circuit breaker pops up it disconnects the power. Wait two minutes and push to reset.
If it pops up again there is a short circuit. Stop and find fault or contact your dealer.
GLOW PLUG LIGHT:
Light is energized when ignition switch is first put in run position. Glow light cycle time
is five seconds.
WATER IN FUEL LIGHT:
Light comes on when engine is running and fuel has water in it.