Dixon ZTR 8026D TESTING OF SAFETY INTERLOCK SYSTEMS, INTERLOCK SWITCH TEST:

17
TESTING OF SAFETY INTERLOCK SYSTEMS:
Do not operate mower if safety switches are not operating properly.
Your Zero Turning Radius Mower is equipped with control interlocks for your safety.
1. The engine will not start if the mower blades are engaged.
2. The engine will not start unless the steering control levers are neutral
"OUT" position.
3. The engine will stop if the mower blade clutch is engaged and the
operator leaves the driver's seat.
4. The engine will stop if the park brake is ON and the steering control levers
are moved to the "IN" position.
INTERLOCK SWITCH TEST:
Note: Operator must be seated in normal operating position to perform these
tests.
1. With engine off, turn mower blade on and attempt to start engine.
Engine should not start .
2. With engine off, move control levers in and attempt to start engine.
Engine should not start.
3. In a SAFE AREA away from bystanders, start the engine, place throttle
setting at maximum or full. Engage the blade drive through the electric
clutch switch. Raise slightly off of seat. Engine should stop .
4. With engine running, set parking brake and move levers inboard.
Engine should stop .
If any safety check fails, do not operate the mower until the system has been checked
and repaired by an authorized Dixon ZTR dealer.
OPERATION INSTRUCTIONS